In almost all cases, whether it is a 2 cycle or 4 cycle engine, golf cart backfiring is caused by the accelerator cable being out of adjustment at the throttle plate of the carburetor. This problem has a relatively simple cure.
Beside the above, why does ezgo golf cart backfire? Your golf cart backfires as there is something wrong with the combustion inside of your golf cart engine. This problem could be related to bad gas, spark plugs, electrical, clutch, or other items. When troubleshooting, always start with the easy fixes and work towards the harder ones.
In regards to, how do you adjust the carburetor on a club car? Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Similarly, how do you adjust the carburetor on a EZ Go golf cart? 2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
Also, what causes golf cart hesitation? If your cart does not start smoothly, hesitates before starting, or does not gain speed properly, these are all signs of a bad or damaged accelerator.
How do you set the timing on a Yamaha golf cart?
How do you adjust the governor on a Club Car gas golf cart?
How do I clean the carburetor on my golf cart?
How do you adjust the idle on a golf cart?
How do you adjust the governor on a EZ GO TXT gas golf cart?
- Locate the governor arm mounted on top of the rear axle case underneath the cart.
- Loosen the adjusting locknut on the end of the governor spring.
- Retighten the adjusting locknut.
How do you clean the carburetor on a EZ Go golf cart?
How can I make my ezgo gas golf cart faster?
How do you diagnose a golf cart problem?
- Test the wall socket where you charge your cart.
- Expose your golf cart batteries.
- Test the batteries for voltage.
- Replace dead batteries.
- Expose the motor for inspection.
- Reset the motor.
- Test the cart.
How do I know if my golf cart solenoid is bad?
- The solenoid needs to be replaced IF the voltmeter shows a full battery voltage without a click.
- If your voltmeter stays at 0, the problem stems from somewhere else in your cart.
How do I know if my golf cart controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
